Turn off the printer, and turn it on again. Contact customer support if this failure is repeated.Īn error occurred in the Authentication feature of the machine.
Contact customer support if this failure is repeated.Īn error occurred during initialization of the high compression board. The fusing unit needs to be replaced soon. Contact customer support if this failure is repeated.
PRINTER AUTHENTICATION ERROR INSTALL
Turn off the printer, and then install the fusing unit. Remove the jammed paper, and then try printing again. The number of sheets for the document is insufficient. Close the document feeder and replace the documents. There is a paper jam in the document feeder. The minimum size of the document that can be loaded on the document feeder is 139.7 mm x 139.7 mm.Īn error occurred in the document feeder. Reload a correct size and/or color document and resume operation. Decide whether there is another document.įax Memory is insufficient. Scanning has been completed for all loaded documents. Start the job without any changes or cancel the job. When rotation is not available even though the orientation of the document and the image are different and part of the image will be lost if it is not rotated. When scanning a document, the number of pages that has accumulated in the machine has exceeded the value of Maximum Stored Number of pages set in system data. Try to store as much data as the memory capacity and continue scanning the next document. The number of slow-scan lines has exceeded the upper limit due to Fax parallel composition. There was no paper in the tray that can be selected for the machine. Enter a document size from the Control Panel or select a paper tray. Return a document with the correct color again. Return a document with the correct size again. Since the number of documents is insufficient, reload the correct number of documents. Select an appropriate paper tray manually. Clear the B/W setting for Color mode or the Side 2 cover image setting. It is available for scanning a A4/B4 document, reduce the resolution. Memory is not enough, a selected resolution is not available for scanning a A3 document. The reduction/enlargement ratio exceeded the allowed range. Reduce the resolution or the ratio for Reduce/Enlarge to decrease the data size, or split the data to send it separately. Place the Calibration Chart correctly on the document glass. Cancel copying, and perform the operation for copying again.Ĭheck the 2 Sided Book Copying settings, and try the same operation.Īn error occurred in the document feeder.Ĭheck whether the document is blank or whether the side of the document to be faxed is loaded correctly.Īn incompatible combination of features was specified. Contact customer support if this failure is repeated.Ĭopying is started before the machine exits the Power Saver mode and detects the change for the tray size, when the paper size set in the tray that has been changed during the Power Saver mode. Specify the same Reduce/Enlarge ratio for both sides.
PRINTER AUTHENTICATION ERROR CODE
Check the output, and then replace the documents that have not been copied yet.Ī digital code is embedded in the document to restrict duplication. Too many documents are set in the document feeder after clearing the paper jam. Contact customer support if this failure is repeated.Īn error occurred in the machine. Also, check whether or not the account limit for the Scan service is set when the accounting type is ColorTrack.
Model: Dell Color Smart Multifunction Printer, S3845cdn Error CodesĪn error occurred during the scan job. For status codes that are not listed in this chapter, refer to instructions in each error message. A status code is included in an error message. When an error occurs, the print data remaining on the printer and the information accumulated in the memory of the printer may be corrupted. When you contact customer support about an error, have the status codes and error messages ready. This chapter provides a list of status codes or error messages, and informs you what you can do to clear error messages. The touch panel displays error messages describing the current state of the printer and indicates possible printer problems you must resolve.